|

You could be dealing with an outdated electrical system in an old house, or you may be facing wires tampered with by an inexperienced do-it-yourselfer. Whatever it is, keep in mind that electrical code violations put both people and property at risk. If you suspect an electrical violation in your home, call a certified electrician to mitigate any potential danger. Check out 5 of the most common electrical code violations below:

Problems with Knob and Tube Wiring

In the early 1800s and 1900s, these types of wires were dubbed state of the art. However, in today’s modern era, knob and tube wiring are fire hazards because they aren’t grounded. These wires can only support lower amperage, which is contradictory to the power-guzzling gadgets of today. These wires have insulation that degrades with time so it is vital to hire an electrician to inspect your home and update this type of wiring. Though re-wiring can cost a pretty penny, it can save your life and that of your hard-earned belongings.

New Light Fixtures Installed With Old Wires

If you put new lights with old wires, you can overload the old wiring. Modern lights run at a hotter temperature, resulting in overheating. When something it’s too hot, it is more combustible. If you want to put new lights in a home that has wiring from 1987 and below, you need a splice box. An electrician can readily put this so you don’t have to rewire the entire circuit.

Dealing with Overcrowded Wires

It can be tempting to cram 4 to 5 wires in a tiny hole during the rough-wiring stage. However, this results in damage because the insulation of the wire can be turned off by the other wire dragging next to it. This can go unnoticed, leaving exposed conductors which are fire hazards. As a standard practice, there should be no more than 3 wires per 7/8-inch hole to leave room for any shifts. Hire an electrician to replace the wire and install a junction box.

Unrated Recessed Lights Touching Insulation

Any recessed light that comes in contact with your attic’s insulation must bear an IC rating. Otherwise, there ought to be a three-inch space between the insulation and light fixture. This can lead to overheating and a fire. Double-check to ensure you have properly rated IC lights. When in doubt, seek professional advice.  

Incorrect and Illegal Splices

One of the worst violations is a splice, connecting two or more wires. This is very dangerous if they’re not done correctly inside a junction box. Technically, you can only make this splice for temporary lighting or troubleshooting circuits. If you need a splice, hire a certified electrician to do the job. Only a reputable one can correct the most common electrical code violations. Remember, if you feel that something is off, don’t wait before it’s too late. This is for the safety of your loved ones. It will also safeguard your possessions which you painstakingly worked hard to invest in.  We service many cities in Indiana. Check out our locations here: Anderson, Carmel, Evansville, Fort Wayne, Indianapolis, Jeffersonville and South Bend.

home services blog

About Us

Privacy policy

HELP & SUPPORT

Don't miss a thing